New day cooling tower packing _ Parts Factory _ cooling tower packing date provided by the new cooling tower parts factory. Fillers | New Day Cooling Tower Parts Factory | cooling tower gambrel wave filler is a new day Anqiu Xin'an streets cooling tower parts factory (www.aqxinri.com) watering filler bonding in 2014 launched a new upgrade, installation: According to actual site selection bottoms bonding assembly. Water spray adhesive to firmly packing, assembly immediately after a restraining plate, sheet molding itself to prevent warping caused unglued. . Before moving position after drying adhesive placed on flat ground, stacking height of not more than two meters, to prevent long-term exposure. When installing the upper and lower mounting block adjacent layers perpendicular orthogonal emissions, installation partition, neat placement dedicated cooling tower packing, inter-block S-wave filler fills tight squeeze on the corners, columns week, irregular voids tower Week part of the actual boundaries cut right filler, ensuring neat placement covering tight packing, the maximum gap does not exceed 20 mm. The installation process and the level of inter-layer packing and timely clean-up, not left scattered debris. e. After filling installation, you need the job on the packing, must be covered with wood, prohibited direct stampede. . Sent someone responsible for checking the quality of the installation, good construction inspection records to ensure quality installation