Drenching fillers should be assembled according to the design, installation requirements. Molded piece design length is generally divided into four 1.0,1.25,1.5,2.0M specifications for different engineering design choice. Taking into account the installation and maintenance of convenient packing replacement, each cell assembly block volume should not exceed 0.5M3. When tricking filler using a bonded assembly, packing cooling tower should be on a flat surface, the scene of ambient temperature not lower than 5 ℃. It must immediately pressed with a flat plate after a group of Bahrain, to prevent warpage from molded sheet itself unglued packing after drying the adhesive consolidation before moving position placed flat on the ground, stacking height should not exceed 2M. Prevent long-term exposure. Cooling tower packing replacement should be based on the tower layout situation, there are plans to cut small pieces of irregular gap fillers. Should fill the tight squeeze between the assembly block. Between the packing and the column wall, shaft, and column should fill tight squeeze, the maximum gap should not exceed 20MM. The installation should pay attention to the assembly blocks up and down direction, each laying flat top surface to the interlayer to clean up, do not have clogged. The cooling tower accessories new plant cooling tower packing _] [_ packing date provided by the new cooling tower parts factory. Looking for a "cooling tower accessories, cooling tower fill" reliable supplier, choose the whole network business alliance Certified: Anqiu new date Xin'an Street tower parts factory (www.aqxinri.com), trustworthiness and reliability, now click on "Commercial Union Support" on page with our live chat now!